Filter
Top Products
OkiLAN 6200e Plus User’s Guide
TCP/IP 153
• yourqueuename - This is the name of the queue
on the Network Print Server and must end with 1,
2, 3 or 4, depending on the port selected to service
the print jobs. If FF, LF or NF are the last two letters
of the queue name, the job will be converted
accordingly. See the section on Remote Queue
Names.
Prerequisites
Before you proceed, the following prerequisites must
be met. Most of the time steps 2 through 5 are already
configured since the HP-UX system is on a TCP/IP
network. Do not perform steps 2 through 5 unless
the installation procedure fails!
1. The name OKIPRINTER and the IP address
assigned to the Network Print Server are in the “/
etc/hosts” file on the HP-UX system.
2. Make sure the rlp process is not running by typing
at the UNIX prompt: ps -e | grep rlp If rlp is not
running, you will not see any output after executing
this command. If rlp is running (that is, if you see
output after executing this command), kill the pro-
cess with the command: kill -15 process_number.
3. Make sure the following entry is in the “/etc/
inetd.conf” file: printer stream tcp nowait root “/
usr/lib/ rlpdaemon” rlpdaemon -i If the rlp dae-
mon is not running when a print request is made,
this entry in “/etc/inetd.conf” will tell inetd to auto-
start the rlp daemon and service the pending print
request. This is helpful if the daemon died or was
terminated for some reason. For more information
on inetd or “/etc/inetd.conf”, type man inetd or
man inetd.conf.