Panasonic AV-HS450N Switch User Manual


 
148
5. System settings
Camera control settings
Five cameras can be controlled either through the controller that is used for the camera (AW-RP555N or
AW-RP655N) connected to the COM connector, or through the controller that is used for the pan-tilt head.

Press the [CAM] button to light its indicator and display the CAM menu.
Refer to “2-1-5. LCD menu area”.

Turn [F1] to display the CamCTL1 sub menu.
<Menu display>
CAM 1
|
CTL
|
Signal
|
Tally
|
Protcol
CamCTL1 | 1| None|Disable|P/TCont
1~5 IN1~16
IN-A1
IN-A2
IN-B1
IN-B2
Enable P/TDirt

Turn [F2] to set the control signal (for the camera) that supports the input signal using the CTL item.
Establish the associations between the switching of the cameras linked to the selection of the crosspoint
buttons (PGM/A 1 to 32 and PST/B 1 to 32) and the tally control.
When camera control is enabled, the “c” mark appears on the multi view display in front of the names of
the materials in the cameras targeted for control.
When “P/TDirt” has been selected as the Protcol item, only “1” appears.

Turn [F3] to select the input signal using the Signal item.

Turn [F4] to enable or disable tally control using the Tally item.
This setting can be selected when “P/TDirt” has been selected as the Protcol item.
Enable: Tally control is enabled.
Red tally signal On/Off control is exercised from the RS-422 interface connector.
Disable: Tally control is disabled.

Turn [F5] to set the device to be controlled using the Protcol item.
P/TCont: The controller for the camera or controller for the pan-tilt head is controlled.
Select this when the controller is to be connected to the unit and a multiple number of cameras
and/or pan-tilt heads are to be controlled.
P/TDirt: Select this when a pan-tilt head is to be connected directly to the unit and the camera and the
pan-tilt head are to be controlled.