Filter
Top Products
Connect the power cord to the projector body.1)
Connect the power plug to an outlet.2)
The power indicator <ON(G)/STANDBY(R)> lights or blinks, and the projector will enter the standby mode. f
Press the <3) v/b> button on the control panel or on the remote control.
The power indicator <ON(G)/STANDBY(R)> lights in green and the image is soon projected on the screen. f
Attention
Using the projector while the lens cap is attached may cause the device to heat up and result in a re. f
Note
If the [PROJECTOR SETUP] menu f → [ECO MANAGEMENT]→[STANDBY MODE] is set to [ECO], it may take approx. 10
seconds longer before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.
Making adjustments and selections
It is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.
3)
5)
3)
Adjust the focus of the image roughly. (1) Æpage 38)
Change the settings of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on 2)
the installation mode. (Æpage 25)
Refer to “Navigating through the menu” ( f Æ page 45) for the operation of the menu screen.
Press the <INPUT SELECT> button on the control panel or the input selection (<COMPUTER 1>, 3)
<COMPUTER 2>, <HDMI>, <VIDEO>,<S-VIDEO>) buttons to select the input signal.
Adjust the front, back and sideway tilt of the projector with the adjustable feet. (4) Æpage 28)
If the input signal is an analog RGB signal, press the <AUTO SETUP> button.5)
Adjust the size of the image to match the screen with the zoom ring.6)
Adjust the focus with the focus ring.7)
Note
When the projector is switched on for the rst time after purchase as well as when the [PROJECTOR SETUP] menu → f
[INITIALIZE ALL] is executed, the initial setting screen is displayed after projection starts. Refer to “Start-up display” for
details. (Æ page 19)
Powering On the Projector
Before switching on the projector, make sure all the other devices are correctly connected (Æpages 31-32 ) and remove the
lens cap.
3)
3)
2)1)
36 - ENGLISH
Chapter 3 Basic Operations - Powering on/off