Filter
Top Products
[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (Æpage 45) for the operation of the menu screen.
After selecting the item, press f asqw to set.
[STATUS]
You can check the using status of the projector.
Press 1) as to select [STATUS].
Press the <ENTER> button.2)
The [STATUS] screen is displayed. f
[SIGNAL]
[NAME] Displays the name of input signal.
[FREQUENCY] Displays the scanning frequency of input signal.
[RUNTIME]*
1
[PROJECTOR] Displays the current usage time of projector.
[LAMP
(ET-)]
[NORMAL]
[ECO1]
[ECO2]
Displays the operation time of lamp in each mode (NORMAL/ECO1/ECO2).
It may differ from the actual runtime under the each setting of [NORMAL]/
[ECO1]/[ECO2] in [LAMP POWER] menu.
And, displays the model no. of the replacement lamp unit for this projector.
[SERIAL NUMBER] [PROJECTOR] Displays the serial number of the projector.
The following conversion is required to calculate the rough estimate for lamp replacement.*1
Formula for lamp replacement time (rough estimate)
A x 1 + B x 0.8 + C x 2/3
A : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [NORMAL] f
B : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO1] f
C : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO2] f
[COMPUTER2 SELECT]
Set whether to use the <COMPUTER 2 IN/1 OUT> terminal.
Press 1) as to select [COMPUTER2 SELECT].
Press 2) qw to switch the item.
The items will switch each time you press the button. f
[COMPUTER2 IN] When input the computer signal.
[COMPUTER1 OUT] Outputs the signal which have been input <COMPUTER 1 IN> terminal.
Note
The [COMPUTER2 SELECT] will be unavailable when COMPUTER2 is selected as input source. f
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side to enable
simultaneous control or individual control via a single remote control.
Press 1) as to select [PROJECTOR ID].
Press the <ENTER> button.2)
The [PROJECTOR ID] screen is displayed. f
66 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu