Filter
Top Products
[Ping test] page
Check whether the network is connected to the mail server, POP server, DNS server, etc.
Click [Detailed set up] → [Ping test].
1
2
3
4
[Input IP address]1
Enter the IP address of the server to be tested.
[Submit]2
Executes the connection test.
Example of display when the connection has 3
succeeded
Example of display when the connection has failed4
[E-mail set up] page
When there is a problem or the runtime of a lamp reaches a set value, an E-mail can be sent to preset E-mail
addresses (up to two addresses).
Click [Detailed set up] → [E-mail set up].
1
2
3
4
5
6
[ENABLE]1
Select [Enable] to use the E-mail function.
[SMTP SERVER NAME]2
Enter the IP address or the server name of the E-mail
server (SMTP). To enter the server name, the DNS
server needs to beset up.
[MAIL FROM]3
Enter the E-mail address of the projector. (Up to 63
characters in single byte)
[MEMO]4
Enter information such as the location of the projector
that noties the sender of the E-mail. (Up to 63
characters in single byte)
[MINIMUM TIME]5
Change the minimum interval for the temperature warning
E-mail. The default value is 60 minutes. In this case,
another E-mail will not be sent for 60 minutes after
sending the temperature warning E-mail even if it reaches
the warning temperature.
[INTAKE AIR TEMPERATURE]6
Change the temperature setting for the temperature
warning mail. A temperature warning E-mail is sent when
the temperature exceeds this value.
ENGLISH - 85
Chapter 4 Settings - [NETWORK] menu