Filter
Top Products
Note
Certain signals may not be adjustable. f
Optimal value may not be achieved if the output from the input computer is unstable. f
To project a signal with dot clock frequency with 162 MHz or higher, noise may not disappear even if [CLOCK PHASE] is f
adjusted.
[CLOCK PHASE] cannot be adjusted when a digital signal is input. f
[OVER SCAN]
Use this function when characters or pictures are cropped near the periphery of the projected image.
Press 1) as to select [OVER SCAN].
Press 2) qw or the <ENTER> button.
The [OVER SCAN] individual adjustment screen is displayed. f
Press 3) qw to adjust the level.
The adjustment value are 0 to +3. f
Note
It is unavailable for still image signals, HDMI signals and [NETWORK]. f
[ASPECT]
You can switch the aspect ratio of the image.
The aspect ratio is switched within the screen range selected in [SCREEN SETTING]. Set [SCREEN SETTING] rst.
(Æ page 62)
[SCREEN SETTING] is only for PT-VW340Z.
Press 1) as to select [ASPECT].
Press 2) qw or the <ENTER> button.
The [ASPECT] individual adjustment screen is displayed. f
Press 3) qw to switch the item.
The items will switch each time you press the button. f
[NORMAL] Displays images without changing the aspect ratio of the input signals.
[AUTO]*
1
The aspect ratio is automatically switched to the optimum aspect ratio when an aspect ratio identier is
included in the input signal.
[WIDE]
Displays images with the aspect ratio converted to 16:9 when standard signals*
2
are input.
Display images without changing the aspect ratio when wide-screen signals*
3
are input.
[H FIT]
Displays images using the entire width of the screen. When signals have the aspect ratio vertically longer than
the aspect ratio of the screen selected in [SCREEN FORMAT]*
4
, the images are displayed with the top and
bottom parts cut off.
[V FIT]
Displays the height of the panel pixels vertically without changing the aspect ratio when wide-screen signals
are input. When signals have the aspect ratio horizontally longer than the aspect ratio of the screen, the
images are displayed with the right and left parts cut off.
[FULL]
The image is projected using all the panel (screen) pixels. The input signals are converted to the aspect ratio
of the panel (screen).
[NATIVE] Displays images without changing the resolution of the input signals.
Only for Video (NTSC) and 480i (YC*1
B
C
R
) signals input
Standard signals are input signals with an aspect ratio of 4:3 or 5:4.*2
Wide-screen signals are input signals with an aspect ratio of 16:10, 16:9 or 15:9.*3
[SCREEN FORMAT] is only for PT-VW340Z.*4
ENGLISH - 57
Chapter 4 Settings - [POSITION] menu