Filter
Top Products
Powering Off the Projector
1) 2)
1) 2)
2)
3)
2)
Press the <1) v/b> button on the control panel or on the remote control.
The following message appears. f
Press 2) qw to select [OK], and press the <ENTER> button.
OR
Press the <v/b> button on the control panel or on the remote control again.
Projection of the image will stop, and the power indicator <ON(G)/STANDBY(R)> lights in orange. (The fan keeps f
running.)
Wait until the <ON(G)/STANDBY(R)> indicator lights/blinks in red/green.3)
The projector enters standby mode when the power indicator <ON(G)/STANDBY(R)> lights/blinks in red/green. f
Note
Do not put the projector in a case before the projector is cooled enough. f
While the <ON(G)/STANDBY(R)> indicator is lighting in orange, the lamp is being cooled down and the projector cannot be f
turned on. Wait until the <ON(G)/STANDBY(R)> indicator stops lighting/blinking in red to turn on the projector again.
Direct Power Off function
You can disconnect the power cord from the wall outlet or turn off the breaker even during projection.
Note
When using the Direct Power Off function, you cannot restart the projector immediately after the power is disconnected. The f
lamp remains high temperature and needs to be cooled, so it sometimes takes longer time than usual for the lamp to light up
again.
ENGLISH - 37
Chapter 3 Basic Operations - Powering on/off