Filter
Top Products
[LAMP POWER]
Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
Press 1) as to select [LAMP POWER].
Press 2) qw to switch the item.
The items will switch each time you press the button. f
[NORMAL] Select when high luminance is required.
[ECO1] Select when high luminance is not required.
[ECO2] Select when high luminance is not required and the operation sound is needed more quiet.
Note
You can reduce power consumption and operation noise, and extend the life of the lamps by setting to [ f ECO2] rather than
[ECO1], or by setting to [ECO1] rather than [NORMAL].
[ECO MANAGEMENT]
This function optimizes lamp power according to the operating status to reduce power consumption.
Press 1) as to select [ECO MANAGEMENT].
Press the <ENTER> button.2)
The [ECO MANAGEMENT] screen is displayed. f
Press 3) as to select one item.
Setting [AUTO POWER SAVE] in step 3)
Set whether or not to enable the three functions, [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE
DETECTION].
Note
[AUTO POWER SAVE] cannot be set when the [LAMP POWER] is set f to [ECO2].
Press 4) qw to switch the [AUTO POWER SAVE].
[ON] Enables power-saving mode.
[OFF] Disables power-saving mode.
Press 5) as to select one item.
[AMBIENT LIGHT DETECTION] Adjusts the lamp power according to the ambient brightness.
[SIGNAL DETECTION] Drops the lamp power when no signal is input.
[AV MUTE DETECTION] Drops the lamp power in the AV mute mode.
Press 6) qw to switch the item.
The items will switch each time you press the button. f
[ON] Enables above setting.
[OFF] Disables above setting.
Note
Lamp power cannot reduced automatically in the following cases: f
- When [LAMP POWER] is set to [ECO2]
- When the lamp lit or the setting of [LAMP POWER] is completed, etc.
When [AUTO POWER SAVE] is set to [OFF], [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and [AV MUTE f
DETECTION] cannot be set.
[AMBIENT LIGHT DETECTION] will not work correctly when placing some objects on the ambient luminance sensor. f
Setting [POWER MANAGEMENT] in step 3)
Set the operation as following if there is no signal input.
Press 1) as to select [POWER MANAGEMENT].
Press 2) qw to switch the item.
The items will switch each time you press the button. f
68 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu