Filter
Top Products
ENGLISH
– 13
Getting Started
l
AUTO SET UP button (p. 47)
Pressing this button while projecting an image
automatically corrects the picture positioning
on the screen. While the auto setup feature is
active, a message “PROGRESS...” appears on the
screen.
m
SHUTTER button (p. 46)
Press this button to black out the image
temporarily.
n
ASPECT button (p. 48)
Switches the image aspect ratio.
o
LENS (FOCUS, ZOOM, SHIFT) button (p. 38)
These buttons are used to adjust the projection
lens.
p
Function 1 (FUNC1) button (p. 47)
This button can control the functions set in
“FUNC1” of the “PROJECTOR SETUP” screen
from MAIN MENU.
q
DEFAULT button (p. 51)
Press this button when you want to restore the
setting of the item selected in the menu to the
factory default value.
r
ID SET button (pp. 18, 75)
When two or more main units are used in the
system, this button specifies the ID of the remote
control.
s
ID ALL button (pp. 18, 75)
When two or more main units are used in the
system, this button switches to the mode to
control them simultaneously with a single remote
control.
t
LOCK button
This button is used to prevent unintentional
operation of the projector by accidentally pressing
a button, and to prevent the remote control
batteries from becoming spent.
u
Remote control transmitter window
Operate the remote control aiming at the remote
control receiver window on the main unit.
v
Remote control wired terminal (p. 18)
To use the wired output terminal, connect the
remote control and the main unit with the cable
(sold separately).
Note
The AUX button to switch the input is disabled •
when an optional input module is not connected.
t
u
v
Side
Top
Bottom