Filter
Top Products
ENGLISH
– 63
Basic Operation
Press ENTER.2.
The “BLANKING” adjustment screen will be •
displayed.
BLANKING
UPPER
LOWER
0
0
Press ▲▼ to select the desired 3.
item for adjustment.
Press ◄► to adjust blanking.4.
The adjustment value can be changed within •
a range of 0 to 384 vertically and 0 to 683
horizontally.
When correcting the upper blanking of the
screen (top)
Press ◄ button to
move the blanking zone
upward; ► button to
downward.
When correcting the lower blanking of the
screen (bottom)
Press ► button to
move the blanking zone
upward; ◄ button to
downward.
When correcting the left hand blanking of
the screen (left)
Press ► button to move
the blanking zone to the
right; ◄ button to the
left.
When correcting the right hand blanking of
the screen (right)
Press ◄ button to move
the blanking zone to the
right; ► button to the
left.
Adjusting the input
resolution
Input resolution adjustment achieves the best image
when the screen flickers or halo is observed around
the contour.
Press ▲▼ to select “INPUT 1.
RESOLUTION”.
BLANKING
INPUT RESOLUTION
CLAMP POSITION
Press ENTER.2.
The “INPUT RESOLUTION” screen will be •
displayed.
INPUT RESOLUTION
TOTAL DOTS
DISPLAY DOTS
1344
1024
Press ▲▼ to select “TOTAL 3.
DOTS”, “DISPLAY DOTS”,
“TOTAL LINES” or “DISPLAY
LINES”, and the press ◄► to
adjust it.
Each item automatically displays a value in •
response to the type of the input signal. If
vertical stripes appear on the screen or the
image is partly missing, increase or decrease
the displayed value while observing the screen
to achieve the optimal value.
Note
The abovementioned vertical stripes will not appear •
on the screen when all signals are input.
The picture may be distorted during the adjusting •
operation, but this is not a fault.
The input resolution can be adjusted only when •
RGB signal input is applied with RGB1 and RGB2
IN.
Adjusting the clamp
position
Use the clamp position adjustment to achieve the
optimal value when dark areas of the image are
crushed or displayed in green.
Press ▲▼ to select “CLAMP 1.
POSITION”.
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING
OFF