Filter
Top Products
42 –
ENGLISH
How to adjust the lens (continued)
Precautions for projector installation work z
When installing and using the projector with a method other than floor standing installation using the adjustable
feet, insert, for example, spacers (metal) between the projector and installation surface so that there is a gap
of about 10 mm to 20 mm to ensure the cabinet does not touch the installation surface. Furthermore, use the
screw holes (shown in the figure) for ceiling mounting to fix the projector in place. (Screw diameter: M6, set
inside screw length: 8 mm)
Note that if the cabinet is touching the installation surface when used, it may take a while until the images
stabilize after the power is turned on.
Base
Gap (10 mm to 20 mm)
Make sure air can circulate
around the air intake
vent. Failure to do so may
result in the projector not
operating properly.
Spacers
Ceiling mounting screws (M6)