Panasonic TQBJ 0268-5 Projector User Manual


 
ENGLISH
45
Basic Operation
Press ENTER.3.
A “Change registered signals” screen will appear.
RENAME
NAME
MEMORY NO
INPUT
fH
fV
SYNC.STATE
SXGA60-A1
A1
RGB1
64.00kHz
60.00Hz
H(POS)
V(POS)
ABCDEFGHIJKLMNO
PQRSTUVWXYZ;:,.
abcdefghijklmno
pqrstuvwxyz/+-*
0123456789 _@[]
< > BS OK CANCEL
Press ENTER.4.
Note
To rename a registered signal, perform steps 4 and
5 on page 44.
Procedure to switch to sub
memory
Press ◄► on normal screen 1.
(menu is not displayed).
The screen will show a list of the sub-memory
registered for the currently entered signal.
Press ▲▼◄► to select the 2.
sub-memory signal to be
switched in the “SUB MEMORY
LIST”.
Press ENTER.3.
Signal will be switched to the one that was
selected in Step 2.
How to erase sub memory
The currently selected SUB MEMORY is deleted
by pressing DEFAULT at the “REGISTERED
SIGNAL LIST”.
On-screen indications
1
Input switching / signal switching
This shows the registered signal name on the
status screen for signal switching.
INPUT
NAME
MEMORY NO
RGB1
RGB
A1(1-2)
2
Details of registered signal
REGISTERED SIGNAL STATUS
NAME
MEMORY NO
INPUT
fH
fV
SYNC.STATE
SXGA60-A1
A5 (1-2)
RGB1
63.98kHz
60.02Hz
H(POS)
V(POS)
The designation can be set by the sub memory
items.
MEMORY NO : A1 (1-2)
Sub memory number
The place in which address code (A1,
A2, ..., H7 and H8) signals are registered
Note
Restrictions
The maximum sub memory items that can be
registered for the projector are 96 including the
basic signal.