Panasonic WJ-GXE500E Webcam User Manual


  Open as PDF
of 73
 
46
Important:
*4 •When"Alarminput"or"Manual"isselectedfor"Savetrigger"onthe[SDmemorycard]tab,imageswill
not be transmitted to the FTP server even when an alarm is detected.
*7 •Dependingonthenetworklinespeedorthenetworktraffic,imagesmaynotbetransmittedattheexact
designated interval or period.
*1 •"Alarminput","Alarmoutput"and"Commandalarm"areactivatedfortheselectedchannel.
*2 •Refertotheinstallationguideforfurtherinformationaboutinput/outputratingofeachterminal.
*3 •Thefollowingportnumbersareunavailablesincetheyarealreadyinuse.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 554, 995, 10 669, 10 670, 52 000,
59 000 - 61 000
*5 •TotransmitalarmimagestoanFTPserver,itisnecessarytoconfigurethesettingsinadvance.(☞ Page
52)
*6 •When"D1"isselectedfor"Imagecapturemode",AlarmFTPimagetransmissionisunavailable.
*8 •Thevalues(transmissionintervalxnumberofimages)willautomaticallybeset.
*9 •When"Open"isselected,thealarmsignalwillbeoutputforaround20secondswhenthepowerofthe
unit is turned on.
[VMD area] tab
Refer to page 28 for general information about this tab.
Setup items Setting values
(Underlined: default)
Ch No.
1/2/3/4
Area 1 (White) / 2 (Blue) /
3 (Green) / 4 (Red)
Status
On/Off
Detection area 1-10(Default:1)
Detection sensitivity 1-15(Default:8)
VMD information addition Information addition *1 *2
On/Off
Important:
•Thealarmoccurrenceindicationbutton(☞ page 13) will be displayed when motion is detected by the VMD
function.
•Thealarmoccurrenceindicationbuttonwillbedisplayedwhenreceivinganalarminputofaterminalalarmora
command alarm.
•Dependingonthenetworkenvironment,notificationmaybedelayedevenwhen"Realtime"isselectedfor
"Alarm status update mode" on the [Basic] tab of the "Basic" page (☞ page 30).
•Themotiondetectionfunctionisnotthededicatedfunctiontopreventthefts,fires,etc.Wearenotresponsible
for any accidents or damages occurring in case.
•When"Multicast"isselectedfor"Transmissiontype"onthe[JPEG/H.264](☞ page 34) (or [JPEG/MPEG-4]
(☞ page 37)) tab or "On" is selected for "Priority stream" on the [System] tab, it may sometimes be impossible
to display the VMD area setup window.
 previous next