Panasonic WJ-GXE500E Webcam User Manual


  Open as PDF
of 73
 
60
•AreyouaccessingthewrongIPaddress?
Check the connection as follows
With the Windows command prompt,
> ping "IP address of the unit"
If there is reply from the unit, the connection is normal.
If not, proceed either of the following.
•ReboottheunitandchangetheIPaddressby
using the Panasonic IP setup software within 20
minutes after the restart.
•Reboottheunitwhileholdingthe[INITIALSET]
buttonontheunit.Theunitwillbeinitializedand
the IP address will return to the default setting
"192.168.0.10".
Aftertheunitisinitialized,accesstheunitandset
theIPaddressagain.(Whentheunitisinitialized,
all the settings of the unit previously configured on
thesetupmenuswillbeinitialized.)
54
Installation
Guide
Troubleshooting
Before asking for repairs, check the symptoms with the following table.
Contact your dealer if a problem cannot be solved even after checking and trying the solution in the table or a prob-
lem is not described below.
•Isthepoweroftheuniton?
Check if the power of the unit is turned on.
•IstheLANcable(category5orbetter)firmlyconnect-
edtothenetworkconnectoroftheunit?
Installation
Guide
Installation
Guide
•ArethesetIPaddressesvalid?
•IsthelinkLEDlit?
When it is not lit, connection to a LAN may not be
established or a network may be not working correct-
ly.
Check if the cables have any contact failure or if the
wiring is correct or not.
Reference
pages
Cause/solution
Symptom
Cannot access from the
web browser.
Installation
Guide
54
 previous next