Paradyne 3160 Network Card User Manual


 
Configuration Options
C-26
3160-A2-GB21-80March 1999
Table C-7. User Interface Configuration Options (9 of 10)
MoDiscTm: 5
Next Up Down Save Prev
Modem Port Disconnect Time. Specifies the period of time (1 to 60 minutes) before the
modem port disconnects due to inactivity. (The MoInActTm configuration option must be
set to Enab.) Use the left or right arrow key to position the cursor on the digit you want
to change. Use the Function keys (Up or Down) to increment or decrement the digit.
Up – Increments the time delay.
Down – Decrements the time delay.
Save – Stores the time delay for use with inactivity disconnects.
NOTE: This configuration option is available on standalone DSU/CSUs only.
F
Aux Use: None
Next None Mgmt Daisy Prev
Auxiliary Port Use. Specifies how the auxiliary port is used. The auxiliary port only
supports Point-to-Point Protocol (PPP) with the following parameters: type is
asynchronous, character length is 8, parity is none, and stop bit is 1.
None – Specifies that the auxiliary port is not to be used.
Mgmt – Configures the auxiliary port as the link to an SNMP manager or Telnet client
via an external LAN Adapter.
Daisy – Configures the auxiliary port as an SNMP or Telnet port that is daisy chained to
the communication port of an another 31xx Series device.
NOTE: This configuration option is available on standalone DSU/CSUs only.
F
Aux Rate: 19.2
Next 9.6 14.4 19.2 38.4 Prev
Auxiliary Port Rate. Configures the bit rate for the auxiliary port.
9.6 – Configures the auxiliary port rate as 9600 bps.
14.4 – Configures the auxiliary port rate as 14,400 bps.
19.2 – Configures the auxiliary port rate as 19,200 bps.
38.4 – Configures the auxiliary port rate as 38,400 bps.
NOTE: This configuration option is available on standalone DSU/CSUs only.
F
TnSession: Disab
Next Enab Disab Prev
Telnet Session Enable. Specifies whether the DSU/CSU responds to Telnet session
requests.
Enab – The DSU/CSU responds to Telnet session requests.
Disab – The DSU/CSU does not respond to Telnet session requests.
TnPaswd: Disab
Next Enab Disab Prev
Telnet Password Mode. Specifies whether a password is required for Telnet access.
Enab – A password is required for Telnet access.
Disab – A password is not required for Telnet access.