Paradyne 3160 Network Card User Manual


 
Configuration Options
C-39
3160-A2-GB21-80
March 1999
Table C-10. Management Trap Configuration Options (2 of 3)
Gen Trap: Both
Next Disab Warm Auth Both Prev
General Trap Types. Specifies the general trap types to enable.
Disab – Disables the sending of trap messages for warmStart and authenticationFailure
events.
Warm – Sends trap messages for warmStart events to the currently configured trap
manager(s).
Auth – Sends trap messages for authenticationFailure events to the currently configured
trap manager(s).
Both – Sends trap messages for warmStart and authenticationFailure events to the
currently configured trap manager(s).
NOTE: This configuration option is not available if the SNMP Trap configuration
option (in the
Alarm Configuration Options
section on page C-28) is
disabled.
Entp Trap: Enab
Next Enab Disab Prev
Enterprise Specific Traps. Specifies whether enterpriseSpecific traps are enabled.
Enab – Sends trap messages for enterpriseSpecific events to the currently configured
trap manager(s).
Disab – Disables the sending of trap messages for enterpriseSpecific events.
NOTE: This configuration option is not available if the SNMP Trap configuration
option (in the
Alarm Configuration Options
section on page C-28) is
disabled.
Link Trap: Both
Next Disab Up Down Both Prev
Link Trap Type. Specifies the link trap type to enable. Interfaces monitored for linkUp
and linkDown traps are specified with the Trap I/F configuration option.
Disab – Disables the sending of trap messages for linkDown or linkUp events.
Up – Sends trap messages for linkUp events to the currently configured trap
manager(s).
Down – Sends trap messages for linkDown events to the currently configured trap
manager(s).
Both – Sends trap messages for linkUp and linkDown events to the currently configured
trap manager(s).
NOTE: This configuration option is not available if the SNMP Trap configuration
option (in the
Alarm Configuration Options
section on page C-28) is
disabled.