Filter
Top Products
Configuration Option Tables
A-20
7984-A2-GB20-10February 1999
SNMP Traps Options
SNMP configuration options allow you to specify the information necessary to
support the 7984 termination unit SNMP traps. To access the SNMP Traps
Options screen, follow this menu selection sequence:
Main Menu
→
Configuration
→
Load Configuration From
→
Management and Communication
→
SNMP Traps
main/config/management/trap Hotwire
Model: 7984
SNMP TRAPS OPTIONS
SNMP Traps: Enable
Number of Trap Managers: 5
NMS 1 IP Address: 135.014.040.001 Clear Destination: IMC
NMS 2 IP Address: 135.014.003.027 Clear Destination: IMC
NMS 3 IP Address: 135.014.001.008 Clear Destination: IMC
NMS 4 IP Address: 135.014.002.024 Clear Destination: IMC
NMS 5 IP Address: 204.128.146.035 Clear Destination: IMC
General Traps: Both
Enterprise Specific Traps: Enable
Link Traps: Both
Link Traps Interfaces: Network
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu M
ainMenu Exit
S
ave
Table A-9. SNMP Traps Options (1 of 3)
SNMP Traps
Possible Settings: Enable, Disable
Default Setting: Disable
Controls the generation of SNMP trap messages. The options for addresses and types
of traps are located in this table.
Enable – SNMP trap messages are sent out to SNMP managers.
Disable – No SNMP trap messages are sent out.
Number of Trap Managers
Possible Settings: 1, 2, 3, 4, 5
Default Setting: 1
Sets the number of SNMP management systems that will receive SNMP traps.
1 to 5 – Number of trap managers. An NMS IP address is required for each manager.