Filter
Top Products
Messages and Troubleshooting
6-2
7984-A2-GB20-10
February 1999
Configuring SNMP Traps
An SNMP trap can be automatically sent out through the EOC or the
Management port to an SNMP manager when the 7984 Standalone Termination
Unit detects conditions set by the user. These traps enable the SNMP manager to
gauge the state of the network. Refer to Appendix B,
Standards Compliance for
SNMP Traps,
for details of SNMP traps supported by the 7984 Standalone
Termination Unit.
To configure the 7984 Standalone Termination Unit for SNMP traps, use the
SNMP Traps Options screen to:
H Enable SNMP traps.
H Set the number of SNMP managers that receive SNMP traps from the 7984
Standalone Termination Unit by entering an IP address and network
destination for each SNMP manager specified.
H Select the type of SNMP traps to be sent from the 7984 Standalone
Termination Unit.
To configure SNMP Traps, follow this menu selection sequence:
Main Menu
→
Configuration
→
Load Configuration From
→
Management and Communication Options
→
SNMP Traps Options
main/config/management/trap Hotwire
Model: 7984
SNMP TRAPS OPTIONS
SNMP Traps: Enable
Number of Trap Managers: 5
NMS 1 IP Address: 135.014.040.001 Clear Destination: DSL
NMS 2 IP Address: 135.014.003.027 Clear Destination: DSL
NMS 3 IP Address: 135.014.001.008 Clear Destination: DSL
NMS 4 IP Address: 135.014.002.024 Clear Destination: DSL
NMS 5 IP Address: 204.128.146.035 Clear Destination: DSL
General Traps: Both
Enterprise Specific Traps: Enable
Link Traps: Both
Link Traps Interfaces: Network
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu M
ainMenu Exit
S
ave
Refer to Table A-9, SNMP Traps Options to configure SNMP traps.