Filter
Top Products
Configuration Option Tables
A-21
7984-A2-GB20-10
February 1999
Table A-9. SNMP Traps Options (2 of 3)
NMS
n
IP Address
Possible Settings: 000.000.000.000 – 223.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the Internet Protocol address used to identify each SNMP trap manager.
Address Field – (000.000.000.000 – 223.255.255.255) – Enter an address for each
SNMP trap manager. The range for the first byte is 000 to 223, with the exception of
127. The range for the remaining three bytes is 000 to 255.
Clear – Clears the IP address and sets to all zeros.
NMS
n
Destination
Possible Settings: DSL, COM
Default Setting: DSL
Provides the network destination path of each trap manager.
DSL – The DSL port is the network destination path.
COM – The COM port is the network destination path.
General Traps
Possible Settings: Disable, Warm, AuthFail, Both
Default Setting: Both
Determines which SNMP traps are sent to each trap manager.
Disable – No general trap messages are sent.
Warm – Sends trap message for
warmStart
events.
AuthFail – Sends trap message for
authenticationFailure
events.
Both – Sends both trap messages.
NOTE: Refer to Appendix B,
Standards Compliance for SNMP Traps
.
Enterprise Specific Traps
Possible Settings: Enable, Disable
Default Setting: Disable
Determines if SNMP traps are generated for enterprise-specific events.
Enable – SNMP traps are generated for
enterpriseSpecific
events.
NOTE: Refer to
Enterprise Specific Traps
in Appendix B,
Standards Compliance
for SNMP Traps
.
Disable – No enterprise-specific event traps are sent.