Filter
Top Products
Command Line Interface (CLI) AP-4000 Series User Guide
Other Network Settings
175
Other Network Settings
There are other configuration settings that you may want to set for the AP. Some of them are listed below.
• Configure the AP as a DHCP Server
• Configure the DNS Client
• Configure DHCP Relay and Configure DHCP Relay Servers
• Maintain Client Connections using Link Integrity
• Change your Wireless Interface Settings
• Set Ethernet Speed and Transmission Mode
• Set Interface Management Services
• Configure Wireless Distribution System
• Configure MAC Access Control
• Set RADIUS Parameters
• Set Rogue Scan Parameters
• Set Hardware Configuration Reset Parameters
• Set VLAN/SSID Parameters
• Set Security Profile Parameters
NOTE: See Advanced Configuration for more information on these settings.
Configure the AP as a DHCP Server
NOTE: You must have at least one entry in the DHCP Server IP Address Pool Table before you can set the DHCP
Server Status to Enable.
[Device-Name]>set dhcpstatus disable
[Device-Name]>set dhcpippooltbl 0 startipaddr <start ip address>
endipaddr <end ip address>
[Device-Name]>set dhcpgw <gateway ip address>
[Device-Name]>set dhcppridnsipaddr <primary dns ip address>
[Device-Name]>set dhcpsecdnsipaddr <secondary dns ip address>
[Device-Name]>set dhcpstatus enable
[Device-Name]>reboot 0
CAUTION: Before enabling this feature, confirm that the IP address pools you have configured are valid addresses on
the network and do not overlap the addresses assigned by any other DHCP server on the network. Enabling
this feature with incorrect address pools will cause problems on your network.
Configure the DNS Client
[Device-Name]>set dnsstatus enable
[Device-Name]>set dnsprisvripaddr <IP address of primary DNS server>
[Device-Name]>set dnssecsvripaddr <IP address of secondary DNS server>
[Device-Name]>set dnsdomainname <default domain name>
[Device-Name]>show dns
Figure A-14 Results of “show dns” CLI command