Filter
Top Products
B – Command Line Interface
Set Command
B-24 59021-05 A
port [option]
Sets port state and speed for the specified port temporarily until the next switch
reset or new configuration activation. Refer to the ”Set Port Command” on
page B-37.
setup [option]
Changes SNMP and system configuration settings. Refer to the ”Set Setup
Command” on page B-38.
switch [state]
Temporarily changes the administrative state for all ports on the switch to the state
given by [state]. The previous Set Config Switch settings are restored after a
switch reset or a reactivation of a switch configuration. [state] can be one of the
following:
online
Places all ports online
offline
Places all ports offline.
diagnostics
Prepares all ports for testing.
Examples The following examples enables and disables the beacon:
SANbox2 $> set beacon on
Command succeeded.
SANbox2 $> set beacon off
Command succeeded.