Filter
Top Products
B – Command Line Interface
Set Setup Command
B-38 59021-05 A
Set Setup Command
Changes SNMP and system configuration settings. The switch maintains one
SNMP configuration and one system configuration.
Authority Admin
Syntax set setup
snmp
system
Keywords snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings.
Table B-11 describes the SNMP fields. For each parameter, enter a new value or
press the Enter key to accept the current value shown in brackets.
Table B-11. SNMP Configuration Settings
Entry Description
Contact Specifies the name of the person to be contacted to respond
to trap events. The default is undefined.
Location Specifies the name of the switch location. The default is
undefined.
Trap [1-5] Address Specifies the workstation IP address to which SNMP traps
are sent. The default address for trap 1 is 10.0.0.254. The
default address for traps 2–5 is 0.0.0.0.
Trap [1-5] Port Specifies the workstation port to which SNMP traps are sent.
Trap [1-5] Severity Specifies the severity level to use when monitoring trap
events. The default is Warning
Trap [1-5] Enabled Specifies whether traps (event information) are enabled or
disabled (default).
ReadCommunity Read community password that authorizes an SNMP agent
to read information from the switch. This is a write-only field.
The value on the switch and the SNMP management server
must be the same. The default is “public”.
WriteCommunity Write community password that authorizes an SNMP agent
to write information to the switch. This is a write-only field.
The value on the switch and the SNMP management server
must be the same. The default is “private”.