Filter
Top Products
B – Command Line Interface
Set Setup Command
59021-05 A B-39
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table B-1 2 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity Trap community password that authorizes an SNMP agent
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The default is “public”.
AuthFailureTrap Specifies the IP address where a notification is sent in the
event of an authentication failure.
Table B-12. System Configuration Settings
Entry Description
Eth0NetworkAddress Internet Protocol (IP) address for the Ethernet port.
Eth0NetworkMask Subnet mask address for the Ethernet port.
Eth0GatewayAddress IP address gateway.
Eth0NetworkDiscovery Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 -
RARP)
AdminTimeout Specifies the amount of time in minutes the switch
waits before terminating an idle Admin session.
Zero (0) disables the time out threshold. The
default is 30, the maximum is 1440.
SecurityEnabled Enables or disables the enforcement of account
names and passwords.
LocalLogEnabled Enables or disables the saving of log information
on the switch.
RemoteLogEnabled Whether remote logging of is enabled or disabled.
If enabled, log information is saved to a remote
host that supports the syslog protocol.
RemoteLogHostIPAddress The IP address of the host that will receive the
remote log information if remote logging is
enabled.
Table B-11. SNMP Configuration Settings
Entry Description