Filter
Top Products
2–Configuring NIC
NIC TroubleShooting/Diagnostics
SN0054671-00 B 2-81
You can run additional diagnostics in the CLI as listed in the following table. To
determine the
cna_port_inst, issue the qaucli -nic –i command as shown
in Table 2-15.
Windows Diagnostic Test Descriptions
This section provides descriptions of the following Windows diagnostic tests:
“Hardware Test” on page 2-82
“Register Test” on page 2-82
“Interrupt Test” on page 2-82
“Loopback Test” on page 2-82
“Link Test” on page 2-82
Table 2-15. Running Windows Diagnostic Tests in the CLI
Test Type Command
External Loopback qaucli -nic -extloopback <cna_port_inst>
<tests_num> <on_error>
Where <tests_num> specifies the number of tests,
1–65535, and <on_error> is either 0=Ignore or 1=Abort.
NOTE: This test requires a pass-through module to be con-
figured for both ports. Test runs between two ports. Single
port loopback is not supported.
Flash qaucli –nic –testflash [cna_port_inst]
Hardware qaucli –nic –testhw [cna_port_inst]
Internal Loopback qaucli -nic -intloopback <cna_port_inst>
<tests_num> <on_error>
Where <tests_num> specifies the number of tests,
1–65535, and <on_error> is either 0=Ignore or 1=Abort
Interrupt qaucli –nic –testinterrupt [cna_port_inst]
Link qaucli -nic -testlink [cna_port_inst]
Ping (IPv4) qaucli -nic -ping <cna_port_inst>
<hostname_or_IPv4> [<count> <pocket_size>
<timeout_ms> <TTL>]
Where the default values are count=5,
pocket_size=525, timeout_ms=1000, and TTL=30
Register qaucli -nic -testregister [cna_port_inst]
Transceiver DMI Data qaucli -nic -trans [cna_port_inst]