Filter
Top Products
3–Configuring iSCSI
iSCSI Initiator
SN0054671-00 B 3-5
6. Select the Converged Network Port you want to configure.
7. Select 2, Configure IP Settings.
8. Complete the interactive list of settings as follows:
a. Enable IPv4 [on]: Press the ENTER key to accept the default.
b. DHCP to obtain IPv4 Network Information: [off]: Press
the ENTER key to accept the default.
c. IP_Address []: Type the IP address of the initiator system, and
then press the ENTER key.
d. IP_Subnet_Mask [255.255.255.0]: Type the appropriate
subnet mask, and then press the ENTER key.
e. IP_Gateway [0.0.0.0]: Press the ENTER key to accept the
default.
f. Enable IPv6 [off]: Press the ENTER key to accept the default.
9. On the options menu that opens, select 3, Save changes and reset HBA (if
necessary).
10. At the prompt for both ports, type Yes.
11. To return to the Converged Network Adapter (CNA) iSCSI Configuration
menu, type p and press the ENTER key, and then type p and press the
ENTER key again.
12. On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select 4, Target Configuration.
13. Select the same Converged Network Port you selected in Step 6.
14. Select 6, Add a Target.
15. Complete the interactive list of settings as follows:
a. IPv6 Target? [off]: Press the ENTER key to accept the default.
b. TGT_iSCSI_Name []: Type the iSCSI qualified name (IQN) of the
iSCSI target to connect to, and then press the ENTER key.
c. TGT_Port [3260]: Press the ENTER key to accept the default.
d. TGT_TargetIPAddress [0.0.0.0]: Type the IP address of the
target, and then press the ENTER key.
16. On the options menu that appears, select 12, Save Target/CHAP Changes.
The iSCSI initiator is now configured to connect to the iSCSI target.