Filter
Top Products
2–Configuring NIC
QLogic Device Windows Property Pages
SN0054671-00 B 2-13
Configuring NIC Driver Parameters with QCC GUI
Refer to the QConvergeConsole Help System: Setting General NIC Port
Parameters and Setting Advanced NIC Port Parameters for information.
TCP Checksum Offload IPv4 Enables and disables the TCP transmit and receive
checksum offload.
Registry Key: *TCPChecksumOffloadIPv4
Default: Rx and Tx Enabled
Values: Disabled, Rx Enabled, Tx Enabled,
Rx and Tx Enabled
TCP Checksum Offload IPv6 Enables and disables the TCP transmit and receive
checksum offload.
Registry Key: *TCPChecksumOffloadIPv6
Default: Rx and Tx Enabled
Values: Disabled, Rx Enabled, Tx Enabled,
Rx and Tx Enabled
UDP Checksum Offload IPv4 Enables and the disables the user datagram protocol
(UDP) transmit and receive checksum offload.
Registry Key: *UDPChecksumOffloadIPv4
Default: Rx and Tx Enabled
Values: Disabled, Rx Enabled, Tx Enabled,
Rx and Tx Enabled
UDP Checksum Offload IPv6 Enables and disables the UDP transmit and receive
checksum offload.
Registry Key: *UDPChecksumOffloadIPv6
Default: Rx and Tx Enabled
Values: Disabled, Rx Enabled, Tx Enabled,
Rx and Tx Enabled
VLAN ID for Setting If the Priority and VLAN Tag is enabled, this parame-
ter specifies a VLAN ID for this interface (also
exposed through the standard object identifier (OID)).
Registry Key: VlanId
Default: 0 (no VLAN)
Range: 0-4094
Table 2-1. Windows Driver Configurable Parameters (Continued)
Property Description