Filter
Top Products
Chapter 5 Running Diagnostic Programs
Running the Move Location Test
92 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
14 Press Left to move the highlight to the next number.
15 Repeat steps 13 and 14 as necessary until the desired cycle
count number is displayed.
16 Press Right until the cursor is all the way to the right and the
Select button appears.
17 Press Select to set the cycle count, or press Cancel to return to
the
Diags: General screen without running the Move Medium
test.
The test starts and the GUI displays a
Running Diag screen. The
test stops automatically after completing the selected number
of cycles. When the test is complete, the GUI displays a screen
indicating the test status.
To abort the test before it completes the selected number of
cycles, press
Stop.
18 Press Back.
The GUI displays the cycle count screen.
19 Press Cancel, then Back to return to the Diags: General screen.
Running the Move Location Test 5
The
Move Location test is similar to the Move Medium test, except
that no cartridges are actually moved.
When the
Move Location test is cycled once, the robotic hand is
moved from its current location to the destination location.
When the
Move Location test is cycled more than once, the robotic
hand is repeatedly moved between the destination location and a
home location, and will return to the home location at the end of
Note: Setting the cycle count to 0000 causes the test to run
continuously.