Filter
Top Products
Chapter 5 Running Diagnostic Programs
Running the Move Location Test
94 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
6 Press the Up and Down buttons to select the destination for the
robotic hand.
7 Press Select.
The GUI displays the
Diag: Move Location screen, which
prompts you to set the cycle count (see figure 55
). The
rightmost number is highlighted.
Figure 55 Diag: Move
Location Screen
8 Press the Up and Down buttons to change the highlighted
number.
9 Press Left to move the highlight to the next number.
10 Repeat steps 8 and 9 as necessary until the desired cycle count
number is displayed.
11 Press Right until the cursor is all the way to the right and the
Select button appears.
12 Press Select to set the cycle count, or press Cancel to return to
the
Diags: General screen without running the Move Location
test.
Note: Setting the cycle count to 0000 causes the test to run
continuously.