Filter
Top Products
Chapter 3 Changing the Library Configuration
Setting the Library ID
Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide 55
Setting the Library ID 3
By default the library SCSI ID is set to 0. To change the library SCSI
ID setting:
1 Access the Configuration screen (see Accessing the
Configuration Screen).
2 Press the Up or Down buttons until Library ID is highlighted.
3 Press Select.
4 Use the Up or Down buttons to select the desired SCSI ID.
Available settings are
0 through 15.
5 Press Select.
To return to the
Configuration screen without changing the
option setting, press
Cancel.
6 Press Main to return to the main screen.
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.