Filter
Top Products
Chapter 3 Changing the Library Configuration
Changing the Sync Negotiation Setting
60 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
Changing the Sync Negotiation Setting 3
The
Sync Negotiation option controls whether the library robotics
negotiates synchronous data transfer mode. Normally, this
negotiation is performed by the host.
To enable or disable
Sync Negotiation:
1 Access the Configuration screen (see Accessing the
Configuration Screen on page 53).
2 Press the Up or Down buttons until Sync Negotiation is
highlighted.
3 Press Select.
4 Use the Up or Down buttons to select the desired Sync
Negotiation
setting. The available settings are Enabled and
Disabled.
5 Press Select.
To return to the
Configuration screen without changing the
option setting, press
Cancel.
6 Press Main to return to the main screen.
Note: This option does not enable or disable synchronous data
transfers; it only controls the ability of the library to
negotiate for such transfers.
Note: The default setting is Enabled.
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.