Filter
Top Products
12
The Basics
1. Attach the three
protective rubber
feet to the mounting
bracket when you
use the scanner on a
fl at surface. Do not
use them when you
mount the bracket with
screws.
2. Use the supplied
mounting bracket as
a template to mark
positions for the two
mounting screws.
3. At the marked positions,
drill holes slightly smaller than the screws.
4. Remove the paper backing from each washer and stick
one inside of each bracket’s ear, aligning the washer’s
hole with the bracket’s hole.
5. Attach the mounting bracket to your vehicle’s surface
using the supplied screws and lockwashers.
6. Slide the scanner into the bracket, aligning the scanner’s
holes with the holes in the bracket, and then screw the
mounting knobs into the scanner.
When drilling holes, be sure to avoid obstructions behind
the mounting surface. Consult a qualifi ed installer if in
doubt.
using your scanner as a base station
You can place your scanner on a desk, shelf, or table to use
it as a base station. Since the speaker is on the bottom of
the scanner, you may want to use the mounting bracket to
elevate your scanner off the surface for better sound. Follow
the mobile vehicle mounting instructions above to affi x your
scanner to a desk, shelf, table or other fl at surface (except
that the bracket will be below the scanner).
Note
Note