Radio Shack PRO-2096 Scanner User Manual


 
37
Beyond the Basics
The attenuator is very effective at reducing strong signal
overload interference when using the scanner in areas
close to cellular telephone transmitting facilities.
If you turn on the attenuator, the scanner might not receive
weak signals.
Activating the normal attenuator mode on a Motorola
or APCO Project 25 trunking control channel applies
attenuation to all calls received on that trunking system.
You can press ATT during a trunking call or while manually
tuned to a system control channel to toggle attenuation on
or off for the trunking system.
global attenuator
1. Press FUNC, ATT to set the attenuator to global mode.
Global ATT appears for two seconds, and then ATT- appears.
2. Press ATT to activate the attenuator. ATTon appears on
the bottom of the display. When the scanner stops on a
channel, a appears on the top of the display.
3. Press ATT to toggle global attenuation off. ATT- appears on
the bottom line of the display while scanning.
4. Press FUNC and then ATT again to turn off the global
attenuation mode. Normal ATT appears on the bottom line
for about two seconds.
turning the key tone on or off
Each time you press a scanner key, a tone sounds. You can
turn the scanner’s key tone off or on.
1. To turn the scanner off, turn VOL OFF/MAX counterclockwise
until it clicks.
2. To turn the scanner on, turn VOL OFF/MAX clockwise. Welcome
To Digital Trunking appears on the display.