Filter
Top Products
19
The Basics
searching and tuning
You can search for transmissions using the scanner’s
preprogrammed search banks. The search banks include six
preprogrammed search ranges, SR0 to SR5. You can change
the search range of Bank SR6 manually by setting the lower
and higher ends of the search range.
You can use the scanner’s delay feature while searching.
See “Using Delay”.
You can set CTCSS or DCS mode when searching any
range, except for SR0, SR1, and SR4. The scanner will
display detected CTCSS or DCS codes depending on the
mode setting. See “Using CTCSS and DCS”.
The scanner does not search locked-out frequencies
while searching ranges.
You can use PAUSE to temporarily pause searching. The
scanner will remain on the frequency that was active
when PAUSE was pressed until you press PAUSE again.
You can simply listen to the radio traffi c on the paused
frequency, or copy the frequency to a channel before
resuming your search.
Notes
Notes