Filter
Top Products
96 PARAGON II USER GUIDE
Configuring the AUATC
Press ALT + F2 to activate the Setup Screen, where you can select your desired serial-
communication parameters (baud rate, etc.) and type of local video output. The initial parameters
will always start at their factory defaults, so make sure that the serial port or device to which the
AUATC is attached is temporarily configured for 9600 bps, 8 data bits, no parity, and 1 stop bit.
(If the port or device cannot support all of these settings, you must temporarily attach one that
can.) Also, if you want to perform initial configuration with a local user station, it must consist of
a PS/2 keyboard and VGA monitor.
Available data-rate (“Baud Rate”) settings are 2400, 4800, 9600, and 19,200 bps. You can select
even, odd, or no (“None”) parity; 7 or 8 data bits; and 1 or 2 stop bits (but 7 data bits requires 2
stop bits). The terminal type is fixed at VT100.
To force local VGA output even when your local keyboard is a Sun type, access the AUATC
from a user station with a PS/2 keyboard and a VGA monitor. Activate the Setup Screen and
change the video option from Sun keyboard to VGA. You can then access the AUATC from
Sun type user stations.
Figure 82 Setup Communication Screen