Raritan Computer Paragon II Network Card User Manual


 
90 PARAGON II USER GUIDE
Rear Mount
1. Secure the cable-support bar to the front end of the side brackets, near the side brackets’
“ears,” using two of the included screws.
2. Slide the User Station or Base Unit between the side brackets, with its rear panel facing the
cable-support bar, until its front panel is flush with the back edges of the side brackets.
3. Secure the User Station or Base Unit to the side brackets using the remaining included screws
(three on each side).
4. Mount the entire assembly in your rack and secure the side brackets’ ears to the rack’s front
rails with your own screws, bolts, cage nuts, etc.
5. When you attach cables to the connectors on the rear panel of the User Station or Base Unit,
drape them over the cable-support bar.
Figure 77 Rear rackmount of a P2 Base Unit
Figure 78 Rear rackmount of a P2 User Station