Filter
Top Products
CHAPTER 2: INSTALLATION 19
C. Press F5 to activate the Administration Menu. Use the Ç and È keys to move the
highlight to the Channel Configuration entry and press ENTER to select it.
Figure 25 Administration Menu
D. The Channel Configuration menu appears. Use the Ç and È keys and PageUp and
PageDown keys to approach channel ports to which subsidiary Base Units are connected.
The port default device names appear in the Name column and the device type in the
Device column. (“P242” for a 2 x 42 Base Unit (P2-UMT242), “P442” for a 4 x 42 Base
Unit (P2-UMT442), “P832” for an 8 x 32 Base Unit (P2-UMT832M), or “P1664” for a
16 x 64 Base Unit (P2-UMT1664M).
Figure 26 Channel Configuration Menu for a P2-UMT832M
E. Continue using the Ç and È keys and PageUp and PageDown keys to move the yellow
highlight to the Name field for the channel port number where a subsidiary Base Unit is
installed and press ENTER. The highlight should turn light blue.
F. Type in the name you want to assign to the subsidiary Base Unit on this channel port (the
highlight should turn green when you start typing). Press ENTER when finished, and
then press S to save the new name. All other paths (channel ports) by which that
subsidiary Base Unit is attached to the Base Unit above it will be given the same name
automatically.
G. Press F2 to reopen the Selection Menu; make sure that the channel port(s) of the second-
tier Base Unit are properly established. All paths to that Base Unit should be displayed in
purple.