Filter
Top Products
CHAPTER 2: INSTALLATION 11
Note: Stacking units do not have their own databases and configurations settings, and likewise,
do not have their own network addresses. You cannot configure one using the front panel
controls on UMT S units.
9. Reset Unit (Paragon II Unit Switch): Enables restart of Paragon II unit as if unit’s power had
been physically turned off and back on again.
With Paragon II unit firmware 2B1 and User Station (UST1) firmware 2K10 or higher, either
a power reset or a factory “function” reset can be performed from the front panel of the
Paragon II unit using shortcut button combinations.
Power Reset:
Hold the Ç and È buttons on the front panel of the Paragon II unit simultaneously for
approximately three seconds. When the front panel stops scrolling, release the buttons.
Factory “Function” Reset:
Hold the Ç and È buttons on the front panel of the Paragon II unit simultaneously while pressing
the FUNC button. When the front panel stops scrolling, release the Ç and È buttons, wait an
additional three seconds, then release the FUNC button.
When “Clear Database Hit Ent/ESC?” appears on the LCD, press the ESC button if you want to
exit the screen without clearing the database. To clear the database, press the ENT button; “Clear
All?” appears on the LCD. If you press the ESC button once more, the channel configuration
will be cleared and will be rebuilt later by the UMT. This is called a Partial Reset. However, if
you press the ENT button, both the channel configuration and the user profile and system settings
will be cleared.