Filter
Top Products
68 PARAGON II USER GUIDE
9. Press ENTER again.
10. Press S to refresh the chain.
11. Go to the Channel Configuration screen and confirm that communication addresses have
been refreshed.
Name the Computer Channel on the P2ZCIM Tiered Selection Menu:
1. When viewing the Paragon II Selection Menu or any OSUI menu, press F5 to go to the
Administration Menu.
2. Select the Channel Configuration submenu.
3. Select the P2ZCIM device channel.
4. Press G to bring up a Channel Configuration menu for the P2ZCIM chain.
5. Use the Ç and È keys to highlight the Name field of the computer just connected via
P2ZCIM. The channel for this computer is displayed in white. The channel will display in
black and the highlight will turn yellow when it is selected.
6. Press ENTER - the highlight will turn blue.
7. Type the desired computer name - the highlight will turn green as you begin to type.
8. Press ENTER - the highlight will turn yellow.
9. Press S to save the new name.
Verify and Save Changes:
1. Press F2 to return to the Selection Menu.
2. The Selection Menu will display with the new computer name highlighted in white.
3. Press ENTER to switch to this selected computer.
4. Normal computer access and operation indicates a successful connection.
P2ZCIM LED Status
The LED on the P2ZCIM indicates the CIM’s operational state:
• If the LED blinks rapidly: P2ZCIM does not have a confirmed Communication Address.
• If the LED is primarily off and blinks on every two (2) seconds: P2ZCIM has a confirmed
Communication Address but is not switched to that Address.
• If the LED is on and blinks on/off rapidly when there is KB/MS traffic: CIM has a confirmed
Communication Address and is switched to that Address.
Note: The P2ZCIM will blink from time to time even if there is no keyboard/mouse traffic; this
demonstrates that the P2ZCIM is operating normally and not locked.
• If the LED is blinking on and off but at a regulated, moderate speed (i.e., every half second):
P2ZCIM is acting as Manager of the chain.