Filter
Top Products
M306H7T3-RPD-E User’s Manual 1. Outline
REJ10J0964-0100 Rev.1.00 August 01, 2005 Page 18 of 88
1.4 Specifications
Tables 1.5 and 1.6 list the specifications of the M306H7T3-RPD-E.
Table 1.5 M306H7T3-RPD-E specifications (1/2)
Item Description
Applicable MCU M16C/6H Group M306H7
Usable MCU mode Single-chip mode
Emulation Memory 1MB
Applicable power supply
VCC2=4.0V--5.5V, VCC1=3.0V--VCC2 (Xin: when operating without
division)
VCC2=2.9V--5.5V, VCC1=2.9V--VCC2 (Xin: when operating in a
divide-by-16 or 8-mode)
VCC2=2.0V--5.5V, VCC1=2.0V--VCC2 (Xcin when operating)
*
VCC2=2.0V--2.6V operates only in low power dissipation mode.
Maximum operating frequency 16MHz
X
IN
-X
OUT
Internal oscillator circuit board (OSC-3)
Switchable to external oscillator input
Clock supply
X
CIN
-X
COUT
Internal oscillator circuit (fixed 32.768kHz)
Switchable to external oscillator input
Basic debugging functions
- Download
- Software break (max. 64 points)
- Program execution/stop (allows free-run execution supporting software
breaks)
- Memory reference/setting (reference/setting C-variables, run-time
execution)
- Register reference/setting
- Disassemble display
- C-level debugging, etc.
Real-time trace function
- 32K-cycle bus information recordable
(Bus, external trigger, time stamp)
- 5 trace modes supported (Break/Before/About/After/Full)
- Can be recorded ON/OFF by events
Real-time RAM monitor function
- 1,024 bytes
- Data/last access result
Hardware break function 6 points (Bus detection, interrupt, external trace signal)
Execution time measurement function
Time between program start and stop
Maximum/minimum/average execution time and pass count of specified
four zones.
Count clock: Equal to MCU Clock or 16 MHz
C0 coverage 256KB
Event output Break x1, Event x6
External trigger input TTL level x8
Host machine interface
(see “2.3 Connecting the Host Machine” on
page 22)
Dedicated parallel (PC4701HS)
LPT parallel (PC4701M/PC4701U)
Serial (PC4701HS/PC4701M)
USB (USB 1.1, full-speed)*1
LAN (PC4701HS/PC4701U)
Power supply to emulator AC100--120V, AC200--240V (50/60Hz)
Overseas standards
US EMI standard [FCC part15 Class A]
CE marking [1998 Class A, EN55024: 1998]
*1 Available to connect the host machine that supports USB 2.0. With the USB interface, not all hardware (such as host
machine, USB devices, USB hub) combination will work and guaranteed.