Filter
Top Products
M306H7T3-RPD-E User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0964-0100 Rev.1.00 August 01, 2005 Page 64 of 88
3.7 Trace Window
The trace window is used to show the results of real-time trace measurements.
(1) Trace window
1) Opening the hardware break point setup dialog box
Trace window
Clicking this button opens the trace window.
2) Trace window
Trace window
The trace window is used to show the results of real-time trace
measurements. It has the following four display modes:
- Bus mode
Bus information per cycle can be inspected. The contents are
displayed in order of execution paths.
- Disassemble mode
The execution paths of the executed instructions can be
inspected. The contents are displayed in order of execution
paths.
- Data access mode
Data read/write cycles can be inspected
- Source mode
The execution paths of the source program can be inspected.
The trace window shows the measurement result when a real-time
trace measurement has finished. The trace window remains blank
until the real-time trace measurement in progress finishes.