Filter
Top Products
M306H7T3-RPD-E User’s Manual 2. Setup
REJ10J0964-0100 Rev.1.00 August 01, 2005 Page 43 of 88
Table 2.4 Switch settings of the M306H7T3- PRT (2)
Signal Switch Setting Description
P87
Xcout
Xcin
Connects pin P86/Xcout of the MCU to the user
system.
(Factory-setting)
P86/Xcout
SW5
P87
Xcin
Does not connect pin P86/Xcout of the MCU to
the user system.
CAUTION
Note on Switch Settings:
Always shut OFF power before changing switch setting. Otherwise, internal circuit board may be
damaged.
IMPORTANT
Note on START and CNVSS Switch Settings:
Switch settings of the START and CNVSS are for debugging without the user system connected.
(2) Jumper Switches JP1 to JP7 on the M306H7T3-PRT Board (MCU-dependent)
Table 2.5 Switch settings of the M306H7T3- PRT (3)
Signal Switch Setting of jumper switches
FLX FLX
INT INT
SYNCIN
JP1
Connects pin SYNCIN to internal
circuit of the M306H7T3-PRT.
Connects pin SYNCIN to the user
system via the M3T-FLX160C.
(Factory-setting)
FLX FLX
INT INT
CVIN
JP2
Connects pin CVIN to the user system
via the M3T-FLX160C.
Connects pin CVIN to the user system
via the M3T-FLX160C.
(Factory-setting)
FLX FLX
INT INT
VCCOFF JP3
Pin VCCOFF is to fixed to high..
Connects pin VCCOFF to the user
system via the M3T-FLX160C.
(Factory-setting)