Filter
Top Products
Chapter 6
28
Connecting an external
TAD 6
You can connect an external Telephone
Answering Device (TAD) to the same line as
your machine. When the TAD answers a call,
your machine will “listen” for the CNG (fax
calling) tones sent by a sending fax machine.
If it hears them it will take over the call and
receive the fax. If it does not hear them, it will
let your TAD take a voice message and the
display will show Telephone (for EU) or
Ext. Tel in Use (for Asia).
The external TAD must answer within four
rings (we recommend you set it to two rings).
This is because your machine cannot hear
the CNG tones until the external TAD has
picked up the call. The sending machine will
only send CNG tones for eight to ten more
seconds. We do not recommend using the toll
saver feature on your external TAD if it needs
more than four rings to activate it.
Note
If you have problems receiving faxes,
reduce the ring delay setting on your
external TAD.
Connections 6
The external TAD must be connected as
shown in the illustration below.
Type A 6
For the countries such as USA, Canada,
Spain, Netherlands, Portugal, Poland,
Hungary, Czech, Norway, Asia, Oceania and
etc.
Before you connect an external TAD, remove
the protective cap (2) from the EXT. jack on
the machine.
1 External TAD (Type A to D)
2 Protective cap
Type B 6
For the countries such as UK, France, Italy,
Belgium, Sweden, Denmark and Finland.
2
1
1
1
1