Transmission
34
1
Note
❒ To scan multiple originals using the ADF or ARDF, set originals in a stack.
❒ When sending a fax, the image output at the other end depends on the size
and orientation of paper used in the receiver's machine. If the receiver does
not use paper of the same size and orientation as that of the original, the fax
image may be reduced in size, trimmed at both edges, or divided across two
or more sheets. When sending an important original, ask the receiver about
the size and orientation of the paper in their machine.
❒ Documents longer than 800 mm (32") must be sent by memory transmission
(immediate transmission may not be possible).
❒ If an original jams, press the {Clear/Stop} key, and then carefully remove the
original.
❒ Make sure that all ink, correcting fluid etc., has completely dried before plac-
ing your original. If it is still wet, the exposure glass will become marked and
those marks will appear on the received image.
❒ Generally, place A4, 8
1
/
2
"×11" originals in the landscape orientation (L). If
you place an A4, 8
1
/
2
"×11" original in the portrait orientation (K), the image
is sent rotated by 90°.
❒ You can send the first page from the exposure glass then the remaining pages
from the ADF or ARDF. You cannot change from the ADF or ARDF to the ex-
posure glass. When transmitting from memory, see “Sending multiple origi-
nals using the exposure glass (Memory Transmission)”. When sending
immediately, see “Sending multiple originals using the exposure glass (Im-
mediate Transmission)”.
❒ When using the Internet Fax function, originals are sent at A4 size. Originals
larger than A4 are reduced to A4 size. If the receiver's machine is compliant
with the T.37 full mode, originals are sent at the size specified in the Address
Book.
❒ Information about this machine is printed at the destination. This information
is printed on the side of the paper that is to your left when placing the docu-
ments on the exposure glass or the ADF or ARDF. However, the information
is also printed rotated by 90 degrees if an A4, 8
1
/
2
”×11” original is placed in
the portrait orientation (K).
❒ For acceptable types of originals, see “Acceptable Original Sizes”, “Paper Size
and Scanned Area”, “If the Machine Cannot Detect the Size of Your Original”
and “Original Sizes Difficult to Detect”.