Filter
Top Products
INSTALLATION
ULTRAMATRIX “UMX” SERIES INSTALLATION AND OPERATIONS MANUAL
10
Switch installation – Single unit
The basic installation of a single UltraMatrix switch is an easy and straightforward procedure. To install a single
switch, perform the below steps for all computers/servers that will be connected. It is recommended that all
computers and servers be powered off. When a computer is connected and then booted, the UltraMatrix will
automatically determine the keyboard and mouse types used for that computer and no pre-configuration of the CPU
port is needed. If removing power from a computer or server is not practical, pre-configure the UltraMatrix’s CPU
port to define that CPU port’s keyboard and mouse types. The default keyboard type is PC mode 2 and the mouse
type is PS/2. If the computer being connected uses a PC2 keyboard and PS/2 mouse, no pre-configuration of the
CPU port is needed. If not, pre-configure the CPU port (Steps 5a-f) for the keyboard and mouse types for that CPU
before connecting the computer. This procedure should only be done if the CPUs keyboard and mouse can be
disconnected and re-connected with power applied to the computer without affecting the interface.
Figure 4. Installation - Single unit
PLEASE REFER TO THE SAFETY SECTION
BEFORE INSTALLATION
CPU’s 1
-
16
KVM’s 1
-
4