Filter
Top Products
Wireless network setup
125
2. Using a network-connected machine
10
Select Using the WPS button and click Next.
• For models that support the WPS button, the above window appears.
• If your machine is connected with a USB cable, the above window does
not appear. Disconnect the USB cable if you want to set up the wireless
network using the WPS button.
• If you want to set up the wireless network using the USB cable, refer to
"Access point via USB cable" on page 120.
11
The next window asks you to check if your access point (or wireless
router) supports WPS or not.
If the access point (or wireless router) has a WPS button, select Yes and
click Next.
12
Follow the instructions in the window to set up the wireless network.
•For models with a display screen, follow the steps below:
a Press and hold the (WPS) button on the control panel for about
2-4 seconds.
The machine waits up to 2 minutes for the WPS button on the
access point (or a router) to be pressed.
b Press the WPS (PBC) button on the access point (or wireless
router).
The messages are displayed on the display screen in the order
below:
-Connecting: The machine is connecting to the access point (or
wireless router).
-Connected: When the machine is successfully connected to the
wireless network, the WPS LED light stays on.