2.8
Getting started
Adjusting volume
Ringer volume
1. Press
➛!
or
❿
in standby mode.
The display shows the current ringer volume setting.
2. Press
➛!
or
❿!
until you find the desired loudness. Four levels are
available; 0~3.
You will hear the selected volume and the display will show the level.
Setting ‘0’ turns the ringer off. The machine will work normally even if
the ringer is set to off.
3. The change stores into memory and the machine returns to standby
mode.
Speaker volume
1. Press OHD/V.Req to adjust the speaker volume. If you cannot hear dial
tone, check the phone line connection.
2. Press
➛!
or
❿
repeatedly until you find the desired loudness.
The display shows the current volume level.
3. The change stores into memory and the machine returns to standby
mode.
Alarm volume/Key volume
If you set the alarm volume menu ON, alarm tone sounds when an error
occurs. If you set the key volume menu ON, key tone sounds each time
any key is pressed.
1. Press Setup and
➛
or
❿
until ‘VOLUME SETUP’ appears, then press
Start/Enter. The display shows ‘ALARM VOLUME’.
2. Press Start/Enter to access the Alarm Volume menu. To access the Key
Volume menu, press
➛
or
❿
until ‘KEY VOLUME’ appears, then
press Start/Enter.
3. Press
➛!
or
❿
to turn the sound ON or OFF, then press Start/Enter.
4. To return to standby mode, press Stop.
KEY volume ON
KEY volume OFF
DIAL volume ON
1)*Auto dial : OFF
2) Manual dial : ON
ON
OFF
KEY volume
*Auto dial : Broadcasting, Delay TX, Priority TX, Onetouch/Speed dial TX
03-Getting Started 2000/04/03 3:20 PM Page 9