SATO CL412E Printer User Manual


 
SERVICE MODE
The Service mode is exited by powering the printer off and
then back on.
COUNTER MODE
The Counter Mode is provided to allow the user to access the internal printer
cousters.
ADVANCED MODE
The Counter Mode is accessed from the Advanced Mode.
Press the LINE key to step to the Counter Mode.
COUNTER MODE
Pressing the FEED key will advance the display to the counter
selections.
SELECT COUNTER
HD DSP CUT LIFE
The counters are identified in the display as:
HD: Head Counter (should be reset when print head
is replaced)
DSP: Dispense Counter
CUT: Cutter Counter
LIFE: Life Counter (cannot be reset)
1. Use the LINE key to step the underline cursor to the
desired counter, the Head (HD) counter or the LIFE
counter. The default position is the Head Counter. Use the
LINE key to advance the underline cursor to the desired
selection.
HEAD COUNTER
XXXXX M
2. Pressing the FEED key again will advance the counter to
the Clear mode. All counters with the exception of the
LIFE counter may be cleared.
3. Once the correct setting is underlined, pressing the FEED
key will display the current value (in meters)stored in the
counter.
HD CNTR CLEAR
YES NO
4. Use the LINE key to select the desired setting. If you only
wanted to read the counter value, select NO. If you want
to read the counter and reset it to 0.0, place the underline
cursor under the YES. Once the desired setting is
selected, pressing the FEED key will advance the return
you to the Counters Mode display.
COUNTERS MODE
5. To exit the Counters Mode, turn power to the printer off and
then back on.
TEST PRINT MODE
The Test Print Mode offers five different printer status labels for troubleshooting. If
DSW3-5 is On, the Test Print cycle must be initiated with a Print Start command.
Page 3-22 9001074 Preliminary SATO CL Series “e” Printers
Section 3. Configuration