SATO CL412E Printer User Manual


 
Base Reference Point
Command Structure <ESC>A3H-aaaa-Vbbbb
- = This character is optional. When present, it specifies that
the horizontal offset is in the negative direction. If it is left
out the offset direction is positive.
aaaa = Horizontal Print Offset (see Note 7 for field range)
bbbb = Vertical Print Offset (see Note 7 for field range)
Example: <ESC>A3H100V0050
Placement: Preceding all images that are based on the new base
reference point
Default: Current V and H offset setting
Command Function To establish a new base reference point for the current label. The
base reference point is the top left corner or “origin” from where all
print position commands are based.
This command may be very helpful when using labels less than four
inches wide to place images on the printable label surface. It may also
be used to move images past preprinted fields on a label.
Input to Printer:
A3H0300V0075
Printer Output:
SATO CL Series “e” Printers PN 9001074 Preliminary Page 5-19
Section 5. Programming Reference