Filter
Top Products
setup (for example, make sure that you can print from the client to other
printers on the network.
4. If you have problems with Windows NT queues locking up when the active
print job is deleted, try setting the IP timeout to one minute with the
console command SET IP TIMEOUT 1.
5. There were a number of lpr/lpd-related problems fixed in the V3.46
firmware. Therefore, if you are experiencing intermittent queue problems
and you have an older version of firmware, SATO recommends that you
upgrade to 3.46 or later.
Windows 95/98 Peer-to-Peer Troubleshooting
If you are having trouble printing on a Windows 95 Peer-to-Peer network, check the
following:
1. If the print server does not show up under JetAdmin on a Windows 95/98
Peer-to-Peer network, try removing all of the Windows 95 network
software from the Network Control panel and then reinstalling them as
follows:
• First install the IPX/SPX-Compatible Protocol, the Client for
Microsoft Networks, and the network adapter card driver.
• Restart the system, and then add the HP JetAdmin service.
2. Because of the many changes that have been incorporated in Windows
95/98 Peer-to-Peer printing since its introduction, it is a good idea to
upgrade to the latest version of JetAdmin (available on the HP web site at
http://www.hp.com).
SATO CL Series “e” Printers PN 9001074 Preliminary Page 7-9
Section 7. Troubleshooting