Filter
Top Products
Printer Configuration Commands
I2abcde Serial Interface. Sets the operating parameters for the Serial RS232
interface. Sets the default printer configuration in Flash ROM. See
Serial Interface Parameters command in the Configuration Commands
of Section 5: Programming Reference of this manual for details.
Page 5-
IGa Sensor Type. Selects the sensor type.
a = 0 Reflective (Eye-Mark) sensor.
1 Transmissive (See-Thru) sensor
2 Sensor not used
Page 5-
LD,a,b,c,d,e,
f,g,i, j j
Download Protocol Command Codes. Downloads a user defined set
of Alternate Protocol Command Codes. See Appendix E for details on
the proper usage of this command.
Page 5-
PCaa,bb
PCF,a,.....z
Printer Setting. Sets the default printer configuration in Flash ROM.
See Printer Setting command in the Configuration Commands of
Section 5: Programming Reference of this manual for details.
Page 5-
PHa Print Type. Selects the thermal printing method.
a = 0 Thermal transfer printing
1 Direct thermal printing
Page 5-
PMa Print Mode. Selects desired backfeed operation.
a = 0 No backfeed, continuous operation
1 Tear-Off
2 Cut, backfeed after print
3 Cut, backfeed before print
4 Cut, no backfeed
7 Dispense, backfeed after print
8 Dispense, backfeed before print
Page 5-
POabcc Pitch Offset. Sets the pitch type, direction and offset to be used
a = 0 Cutter
1 Dispense
2 Tear-Off
3 Continuous
b = + Positive offset
- Negative offset
cc = 00 to 99, offset value in dots.
Page 5-
Appendix A: Command Quick Reference
SATO CL Series “e” Printers PN 9001074 Preliminary Page A-13
INSTRUCTION DESCRIPTION PAGE